RP60AUMe
Image: RP60AUMe
Compact motor module for 230V A/C motors. (115V A/C available if required)
Universal mount allows placement in many locations, and allows for maximum job site flexibility. Installations could range from a single gang junction box to large central panels that are custom built for an individual project.
The 60 programmable channels provide a one touch control of individual motors, sub-groups of motors or ALL motors.
Programmable features include:
Programmable Features of the RP60AUMe
60 Programmable addresses
6 Programmable Group addresses: 1st, 2nd, 3rd, 4th, 5th, and 6th Groups.
All channel address (can be turned off if needed)
“Sequential action” channel
“Specific stop” channel
Maintained or Momentary latching Action for motor relay
Reverse motor direction via programming
“Sticky” feature – when enabled, a 2nd push of a directional button will not stop the motor, and the action is always maintained. Sticky can be used on a Main address, Group address and ALL
Fast IR response for momentary style window treatments
X-10 Timing on manual switch inputs
“Intermediate Stops” – automatically position a shade to a defined position, stopping at an intermediate location within the window. Intermediate stops can be used when the close or open direction is pressed, and that address can be a Main Address, a Group Address, ALL, or the Manual inputs. The location of an “Intermediate Stop” is measured as a percentage of travel from the open limit. The RP60AUMe unit is the only control with this ability. A Calibration cycle must be completed to enable intermediate stops. There are 4 intermediate stops
Lamp Control. RP60AUMe can be enabled to control a lighting fixture. Run time is off and power is continually applied
Magnetic Switch as an Override – allows for inputs from a magnetic reed switch to be used as on override allowing you to “Lock-Out” control of a motor when a window or door is open
“Dead Beat Timer” – when turned on: allows a control to operate a total of 120 operations only. When 120 operations have been completed, a shade will only lower. To reset or turn off the “Dead Beat Timer” a programming sequence must be completed
Wind Input – allows for Wind Sensor to be the source of a button press. When a wind event is seen, the RP60 can Open or Close the window covering or awning, re-sampling every 4.5 minutes for the presence of wind. Should wind drop below the set threshold and the timer expire, you can either leave the shade in its new position or return to its original position.
Configurable manual inputs – select and use any type and style wall switch available. Somfy Decorator switches will work well also
Auto Tilt – Should you wish to have RP60 AUMe tilt a Venetian Blind, you can set AUTO TILT allowing for 4 intermediate stop positions, with high accuracy
Reset to Factory Default Feature
Reset everything BUT the Main address to factory Default
Factory Default Settings:
Main Channel 1
Group Channels off,
Maintained latching of relays,
SPDT manual input,
Standard output motor directions,
“ALL” enabled,
Standard button press response time (slow),
Special manual input modes disabled,
Sticky feature enabled on ALL, disabled elsewhere
One Schematic – Many Options
Insert Image - One Schematic.jpg
Every switch option offered comes with only one schematic to wire the motor!
^ back to top
|
