Transmitters & Key Pads

Transmitters:
A fundamental part of the ESI system and are available in:
1,2,3,4, 5, 6, 12, 24 and 60 channels in Infra Red only.
1,2,3,4,6,12 and 24 in Dual RF/IR. Radio Frequency only transmitters are 1 and 4 channel.

You may customize a transmitter with a Logo or label buttons to get a “special” transmitter, specific for any project.

Key Pads IR:

• 6, 12 or 24 channels
• The Hardwired IR Key Pad has an eye built in for use with a Transmitter
• Built in Repeater to filter out any unwanted Infrared noise and boost signal
• Feed back LED to ensure that the installation is working

Key Pads RF:

• Wireless RF Keypads do not have an IR eye and do not require any wire for installation
• Installation is easy, needing no more than a good location without electrical interference to the RR433

Eye/Radio Receivers

Eyes:

• REB:
  A small convenient wall mounted eye
• RE-2S, RE-6S:
  Are our standard eyes that will protrude out of any small, obscure location for the control of a system

Sample Eye Installations

Radio Receivers

• RR:
  Turn any installation into a Radio Remote system by adding a RR433

^ back to top

Switches

SPST Switches:

• Wall Switches / Dry Contacts
• SPST – Light Switch (maintained)
• Doorbell (momentary)

SPDT Switches

• Wall Switches / Dry Contacts
• SPDT – Rocker Switch / 3- position maintained
• SPDT – Rocker Switch / 3 position momentary

^ back to top

Sun & Motion Sensors

Any additional Automation features to a Motorized Window treatment system have been difficult to both install and to use. You can get people excited about owning these additions, however using them can be difficult and often they are eventually abandoned and not used.

Using the “RP Bus”, a Light Sensor can be placed in a window opening. The connection to the RP Bus is made with standard phone cable. Now the system will operate with the Sun as the source of the “Button Press” sending the programmed address command.

Connecting to the RP Bus, the RP60ASM-B now has the ability to be a “Device” on the RP Bus, allowing for programming of the Sun/Motion Sensors from anywhere on the bus. Both modular jacks and standard wire connections are available to make every installation easy.

The LED is Bi-colored:
RED = Programming
Green = test light

Exterior applications can be:

• A simple wall switch can operate a single motor and program automation settings
• Sun and Motion protection is added on the RP60ASM-B control

^ back to top

Companion Controls

• Full Colour Touch-Screens
• Fully Programmable Blind Controller
• Includes Timer Function
• Integrates Other Automation Systems if Desired

Companion 6:

• 180mm diagonal screen with
  
• Programmable Blind Controller Interface
  
• Built in Intercom
  
• Screensaver
  
• Photo Gallery
  
• Command Timer

• Intuitive interfaces
  
• Easily customized
  
• Touch Screen Keypad (It’s Programmable!)
  
• Quick and easy modification of button names and graphics
  
• Re-Program Commands anytime
  
• Any Button Configuration is Possible

A simple “Paper Template” can be inserted behind the glass Touch Screen surface with any graphics desired!

^ back to top